New Pullers and Grips for All Makes and Models

Inner Duct Puller
Standard Expanding Puller
Wire Mesh Pulling Grips (Heavy Duty)

Inner Duct Puller

Designed to install Polyethylene Ducting using a screw-in tapered buttress thread to grip the Inside diameter of the duct.

Also called the Screw-in or Carrot Pulling Eye, this is one of the most commonly used types of pulling device. It has a simple, inexpensive, one-piece construction with two flutes designed to actually cut a thread in the bore of the duct as it is screwed in. Virtually impossible to pull out, this product is hard to beat.

Description	Fits
Inner Duct Puller (3/4")	0.72 to 0.93 ID
Inner Duct Puller (1")	0.94 to 1.15 ID
Inner Duct Puller (1-1/4")	1.26 to 1.44 ID
Inner Duct Puller (1-1/2")	1.48 to 1.66 ID
Inner Duct Puller (2")	1.91 to 2.08 ID
Driving Tool	All Sizes

Standard Expanding Puller

Designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and allows a maximum load to be applied without damage to the ducting.

On thin wall ducting, it is recommended that an outer Duct Sleeve be used to prevent the duct from stretching during installation.

Use of a duct plugger will help prevent mud and slurry from entering past the puller into the ducting.

Description	Fits
Standard Expanding Puller (1-1/4")	1.2 to 1.5 ID
Standard Expanding Puller (1")	0.925 to 1.160 ID
Standard Expanding Puller (1-1/2")	1.45 to 1.75 ID
Standard Expanding Puller (2")	1.7 to 2.15 ID
Standard Expanding Puller (2-1/2")	2.2 to 2.6 ID
Standard Expanding Puller (3")	2.55 to 3.2 ID
Standard Expanding Puller (4")	3.275 to 4.1 ID
Standard Expanding Puller (5")	4.17 to 5.125 ID
Standard Expanding Puller (6")	5.13 to 6.08 ID
Standard Expanding Puller (8")	6.45 to 7.95 ID

Wire Mesh Pulling Grips (Heavy Duty)

Manufactured of Hi-Fatigue plastic coated Aircraft Strand steel cable in various weave designs. Recommended wherever high strength and small size are required. Patented pulling eye is flexible and stress relieving.

Description
Wire Mesh Grip (3/4 – 1-1/4", Double Weave, 24"L)
Wire Mesh Grip (1-1/4 - 2", Triple Weave, 32"L)
Wire Mesh Grip (2 – 2-3/4", Triple Weave, 38"L)
Wire Mesh Grip (2-3/4 – 3-1/2", Triple Weave, 46"L)
Wire Mesh Grip (3-1/2 – 4-1/4", Triple Weave, 52"L)
Wire Mesh Grip (4-1/4 – 4-7/8", Triple Weave, 58"L)
Wire Mesh Grip (4-7/8 – 5-1/2", Triple Weave, 64"L)